03 · Craftsmanship

Close range.

Most of what makes a watch good is invisible at arm's length. This is what the loupe sees: the materials we chose, the way they are cut, and how every surface is finished.

05 chapters · materials & methods

A spindle machining a metal blank, coolant on the surface

01 · Titanium

Strong, light, and difficult on purpose.

Grade 5 titanium is about 40% lighter than steel for a comparable case and does not corrode on the skin. It also work-hardens and dulls tools, so it is cut slowly and cooled constantly. That difficulty is why a sharp titanium edge reads as a sign of care.

Alloy
Ti-6Al-4V
Density
4.43 g/cm³
Close-up render of the OBSIDIAN ONE dial seen through its domed sapphire crystal
Fig. 4 · Domed sapphire over the ONE dial (render)

02 · Sapphire crystal

Harder than everything it will meet.

Synthetic sapphire sits at 9 on the Mohs scale, second only to diamond. Each crystal is ground, domed and polished, then coated against reflection on both sides, so the dial reads as if nothing were between it and the eye.

  • Mohs hardness · 9
  • Anti-reflective · both sides
  • Caseback · sapphire, all references

03 · Precision machining

Measured in hundredths, checked in thousandths.

Cases are turned and milled from solid bar. Movement parts are cut, then measured against their drawing before any finishing begins: a part that is not right before it is beautiful never becomes beautiful.

A turning tool cutting a metal rod on a lathe
Fig. 5 · Turning
A lathe chuck and tool post seen at close range
Fig. 6 · Holding the part

04 · Finishing

Every surface has a finish. Every edge has an angle.

Calibre OB-01 at high magnification: bridges, jewels, screws and the main plate

Calibre OB-01 · overview

  1. 01

    Perlage

    Main plate

    Overlapping circles grained one at a time with a rotating peg. It catches light in a fine, regular shimmer.

  2. 02

    Côtes de Genève

    Bridges and rotor

    Parallel bands made with an abrasive wheel, run across all the bridges as if they were one surface.

  3. 03

    Anglage

    Every bridge edge

    The edge is bevelled at an angle and polished to a mirror, so each outline reads as one clean line of light.

  4. 04

    Countersunk jewel

    Each pivot

    A synthetic ruby bearing set in a polished conical sink that frames it and reflects the light around it.

  5. 05

    Blued screw

    Bridges and rotor

    Polished steel heated until the surface turns deep blue. The colour comes from the oxide layer, not from paint.

  6. 06

    Balance and hairspring

    Under the cock

    The regulating organ, left visible from the back. Its finish is about precision more than decoration.

05 · Movement assembly

One watchmaker, one movement, start to finish.

  1. A Inspection of every component under magnification
  2. B Assembly of barrel, train and escapement
  3. C Fitting and poising of the balance
  4. D Regulation in six positions over several days
  5. E Casing, then a final run before the watch leaves the bench
A watchmaker working at a bench microscope
A movement on the bench beside a fine screwdriver

See where every finish ends up.

Explore the collection